Car-O-Liner D20 Instruction Manual page 31

Speed Draw aligner D20
(138 03 85 231, rev. 0), 2001-04, GB/US
2 Clean the area on the vehicle to which the pulling clamp is to be
fastened to ensure a good grip.
Note! Always use an approved pull chain such as Car-O-Liner T17 and
ensure that the pulling clamp, hook and plate are in good shape.
3 By making a loop, the pulling chain is secured to the chain holder
at the back of the draw aligner arm. Make a loop by placing the
chain around the draw aligner arm. Secure the loop by hooking the
chain hook to one of the chain links.
Note! By untighten the locking device on the chain holder, you can continu-
ously adjust the chain holder along the draw aligner arm.
IMPORTANT! To obtain maximum performance and to avoid damage to
the draw aligner, the pulling chain must run in the same direction as the
hydraulic cylinder.
4 Fasten the pulling clamp to the damaged part of the vehicle.
5 Secure the pulling chain and the pulling clamp by fastening the
safety wire to the draw aligner and to the vehicle.
6 To operate the draw aligner, step on the pedal on the pneumatic
pump.
WARNING! Watch out for flying objects during alignment work. Do not
stand behind or near the draw aligner during a pull. Risk of injury.
4 Operation
Car-O-Liner AB
4.11