Connecting The Draw Aligner To The Lifting Platform - Car-O-Liner D20 Instruction Manual

Speed Draw aligner D20
4.3

Connecting the draw aligner to the lifting platform

(138 03 85 231, rev. 0), 2001-04, GB/US
WARNING! Inspection and maintenance must take place each time the
draw aligner is put to use. Risk of malfunction, which may cause injuries.
To connect the Speed Draw aligner D20 to the lifting platform, you have to
place the hydraulic lift at draw aligner height. This is done as follows:
Note! The draw aligner height is the only height at which the draw aligner
can be connected to the lifting platform.
1 Raise the lifting platform. Regarding operation of the power unit,
please refer to the separate Instruction manual for the power unit.
2 Lower the lifting platform. It will automatically stop at a preset
height, which is the draw aligner height.
3 Place the draw aligner in front of the circular end of the lifting
platform. Make sure that the draw aligner is positioned so that the
draw aligner knob is pointing towards the front of the lifting
platform.
WARNING! Before moving the draw aligner, always place the arm in an
upright position. Risk of tripping.
Figure 4.8 Placing the draw aligner in front of the lifting platform
4 Insert the draw aligner knob into the rail underneath the lifting
platform.
4 Operation
Draw aligner knob
Car-O-Liner AB
4.7