Car-O-Liner D20 Instruction Manual page 19

Car-O-Liner AB
3.3.3 Fitting the pneumatic pump
3.6
1 Remove the nipple cap from the nipple at the upper side of the
cylinder. Also remove the nozzle cap from the hose’s nozzle.
Note! Do not entirely remove the cap from the cylinder and from the
nozzle. The caps should be replaced on the nipple and on the nozzle if the
pump hose is removed.
2 Connect the nozzle to the cylinder nipple.
Nipple
Nipple cap
Figure 3.6 Connecting the pump to the cylinder.
WARNING! Watch out for tripping on loose hoses. Risk of injury.
3 Installation
Speed Draw aligner D20
Nozzle
Nozzle cap
(138 03 85 231, rev. 0), 2001-04, GB/US