ADJ Encore Profile 1000 Color User Manual page 28

Encore Profile 1000 Color
These fixtures have the capability to be linked to one another using the power input and out-
put sockets.
The maximum number of units that can be connected in this manner is 5 fixtures.
After this maximum number has been reached, a new power outlet must be used to accom-
modate any additional fixtures. All linked fixtures must be of the same make and model type.
DO NOT mix fixtures.
Encore Profile 1000 Color
Disconnect the unit from its power source, and remove the power cord from the unit. Once the cord
has been removed, the fuse holder can be seen above the power connection. Use a phillips head
screwdriver to remove the fuse holder. Remove the fuse located inside the fuse holder and replace
with the new fuse. Install the fuse holder and new fuse back in the unit.
Encore Profile 1000 Color
Listed below is a common problem that the user may encounter, and a possible solution.
Unit not responding to DMX:
Check that the DMX cables are connected and wired correctly (pin 3 is 'hot'; on some other DMX
devices pin 2 may be 'hot'). Also, check that all cables are connected to the right connectors. The
fixture may not function properly if the inputs and outputs are not connected in the correct manner.
Encore Profile 1000 Color
Due to the presence of fog residue, smoke, and dust, cleaning the internal and external optical
lenses must be carried out periodically in order to optimize light output.
• Use normal glass cleaner and a soft cloth to wipe down the outside casing.
• Clean the external optics with glass cleaner and a soft cloth every 20 days.
• Always be sure to dry all parts completely before plugging the unit back in.
Cleaning frequency depends on the environment in which the fixture operates (i.e. smoke, fog resi-
due, dust, dew).
ADJ Products, LLC - www.adj.com - Encore Profile 1000 Color User Manual Page 28
Power Cord Daisy Chain
Fuse Replacement
Trouble Shooting
Cleaning