Adj Led Rc2 Operation - ADJ Encore Profile 1000 Color User Manual

Encore Profile 1000 Color

ADJ LED RC2 Operation

The ADJ LED RC2 infrared remote (sold seperately) has many different functions. To control the fix-
ture, you must aim the controller at the infrared sensor and be within the 30-foot maximum operating
range. To use the ADJ LED RC2 you must first activate the fixtures infrared sensor. See the Operat-
ing Instructions section of this manual for detailed instructions.
BLACKOUT - Pressing this button will blackout the fixture.
SELECT PROG - Pressing this button will cycle through static color mode, color change mode,
color fade mode, and auto run mode. Each press of this button will change to the next mode. When
you have found your desired mode, use the "+" or "-" to scroll through the programs or static colors.
When in either color fade mode or color change mode, press the Speed button and use the "+" or
"-" to adjust the running speed. When in static color mode, press the Flash button to activate strobe
and use the "+" or "-" to adjust the strobe speed.
FLASH - This button will activate the strobe effect. You can control the flash rate by pressing the "+"
and "-" buttons. Press this button again to exit strobe mode.
SPEED - Press this button and use the "+" & "-" buttons to adjust the speed of the color change
mode, color fade mode, or auto run.
DMX MODE - This button will cycle between DMX addressing, DMX channel mode, and dimmer
curve selection. Some fixtures will come with different DMX channel modes. This button will switch
between the different modes. Please see the Channel Mode sections of this manual for DMX
modes, values, and traits.
SECONDRY/SOUND ACTIVE - This designates the fixture as a secondry fixture in a primary/secon-
dry configuration. Sound active has no assigned function for this fixture.
SET ADDRESS - Press this button to set the DMX address. Press this button first, then press the
numbers to set the address. If the address is correctly set, all LED's will flash and the unit will auto-
matically go into DMX mode.
R G B W - Press any of these buttons, and then press the "+" or "-" to adjust the brightness. Press
the FLASH button to activate strobing and use the "+" or "-" to adjust the flash speed.
"+" and "-" - These buttons adjust the flash rate and speed of the color change mode, color fade
mode, and auto run. When in color change or color fade mode they are used to find your desired
program. See the Operating Instructions section of this manual for details.
ADJ Products, LLC - www.adj.com - Encore Profile 1000 Color User Manual Page 14