Maintenance Of The Machine; Adjusting The Engine Brake - Robland SD410 Manual

Maintenance of the machine

Warning: always disconnect the machine from its power supply before starting all maintenance works!
The interior parts of the machine must be cleaned regularly in order to avoid accumulation of dust and
woodchips.
Any possible deposit of resin, on the various parts of the tables, must be taken away with a piece of
cloth and a little bit of solvent. Never smoke or have any naked flame near the machine when using
flammable products, avoiding the risk of fire and serious burns for the operator!
The machine parts which need maintenance are the planer hinges and axis. They must be lubricated
on a monthly base using a thin oil such as WD-40.
The life of the motor can be extended by removing the saw dust from the cooling fan and the motor by
using a dust extractor.
All bearings inside the machine are double sealed and lubricated for life, therefore they need no
maintenance.

Adjusting the engine brake

If the run down time of the motor exceeds 10 seconds, the brake will need to be readjusted.
This is done as follows: without removing the motor cowling, turn the bolt holding the ventilator fan on
the motor axle one 1/16 of a turn clockwise and make a brake test.
When needed adjust the brake furthermore until it does not exceed 10 seconds.
The air gap between ventilator fan (brake disk) and brake liner (Ferrodo) is factory set at 0.25 mm.
54
Nederlands Français English Deutsch
1 Moot frame
2 Key
3 Spring
4 Motor axle
5 Air gap
6 Electromagnet
7 Mobile disk
8 Locking nut
9 Adjustment bolt
10 Washer
11 Braking disk cast iron
12 Brake liner (Ferrodo)
V0114 SD410 - S410