Operating Instructions - Robland SD410 Manual

Operating instructions

The following recommendations for safe working procedures are given as an example, on top of all the
information specific to this machine and necessary for the safe use as an example.
When working with the machine, safety equipment must be used.
The user must follow the operator instructions in order to avoid accidents.
TRAINING OF MACHINE OPERATORS
It is essential that the operators of the machine receives thourough training regarding operating and
adjusting of the machine
In particular:
the risks involved in working with the machine.
the operating principles, the proper use and setting of the machine.
the correct selection of the tool for each operation.
the safe handling of the parts to be processed.
to the position of the hands in relating to the cutting tools.
Storing the workpieces before and after machining them.
STABILITY
In order to be able to use the machine safely, it is essential to place it stable on the floor.
ADJUSTMENT AND INSTALLATION OF THE MACHINE
Before adjusting the machine, it must be disconnected from the mains.
When installing and adjusting the tools the recommendations of the manufacturer should be followed.
The tool must be properly sharpened and installed.
HANDLING OF TOOLS
When handling the knives, one should always wear protective gloves to avoid severe cuts.
Even blunt tools can cause serious injuries to your hands.
INTENDED USE OF THE MACHINE
The machine may only be used for the processing of wood.
SETTING THE PLANING GUIDE
The guide must always be used for planing and squaring to ensure proper and safe guidance of the
workpiece
42
V0114 SD410 - S410
Nederlands Français English Deutsch