Switching Module Probe Commands; Bcm; Debugging Physical Lsw - H3C MSR Series Probe Command Reference

Switching module probe commands

bcm

Use bcm to execute probe commands for a Broadcom chip.
Syntax
bcm chassis-num slot-num/subslot-num chip-num string
Views
Probe view
Predefined user roles
network-admin
network-operator
Parameters
chassis-num: Specifies a chassis by its number, which is always 0.
slot-num: Specifies a slot by its number in the range of 0 to 255.
subslot-num: Specifies a subslot by its number in the range of 0 to 255.
chip-num: Specifies a chip by its number in the range of 0 to 31.
string: Specifies probe commands for the Broadcom chip. Use slashes (/) to separate commands.
Usage guidelines
Use this command to execute the specified probe commands for the specified switching chip. If you
specify two or more commands for the string argument, separate the commands with slashes.

debugging physical lsw

Use debugging physical lsw to enable debugging for the specified submodule or all submodules of the
switching module.
Use undo debugging physical lsw to disable submodule debugging.
Syntax
debugging physical lsw { all | acl | ioctl | mac | mc | ni | port | proto | psec | qos | sys | vlan } { all
| error | event | timer }
undo debugging physical lsw { all | acl | ioctl | mac | mc | ni | port | proto | psec | qos | sys | vlan }
{ all | error | event | timer }
Default
Submodule debugging is disabled.
Views
Probe view
3