Advertisement
Quick Links
MRK-XXXXAXS UNPACKING INSTRUCTIONS
TOOLS / PARTS REQUIRED
- #2 Phillips Head Driver
- 7/16" Wrench
- Knife
- Wire Cutters
NOTE: You will need to have Service Tracks (Part# TRACK50) and Service Stand (Part# TRACKL)
readily available in order to complete these instructions
1) Remove Enclosure from skid.
2) Use a knife to remove the stretch wrap that goes around the front Squaring Panel.
3) Using the supplied Allen Key, remove the four Wood Shipping Braces (8 Screws).
SHIPPING BRACE
SCREWS
4) Remove the four #2 Phillips Head Screws holding the Locking Trim Panel on the bottom
of the enclosure. Set the locking trim panel aside for future use refer to provided instructions.
5) Install Service Stand and Service Tracks. Refer to the instructions (I-1002) provided with the
Service Stand/Tracks.
NOTE: Rack will not pull out until the next few steps are completed.
- Service Tracks (Part # TRACK50)
- Service Stand (Part # TRACKL)
- 5/32" Allen Key (Provided in the
instructions stretch-wrapped to the
squaring panel)
ALLEN KEY
REMOVE SCREWS
CUT HERE
(ALWAYS CUT AWAY
FROM YOURSELF)
(4 PLACES)
REMOVE CAPS BEFORE
INSTALLING TRACKS
(2 PLACES)
I-00307
Rev -
Advertisement
Related Manuals for Middle Atlantic Products MRK AXS Series
Summary of Contents for Middle Atlantic Products MRK AXS Series
- Page 1 MRK-XXXXAXS UNPACKING INSTRUCTIONS TOOLS / PARTS REQUIRED - #2 Phillips Head Driver - Service Tracks (Part # TRACK50) - 7/16" Wrench - Service Stand (Part # TRACKL) - Knife - 5/32" Allen Key (Provided in the - Wire Cutters instructions stretch-wrapped to the squaring panel) NOTE: You will need to have Service Tracks (Part# TRACK50) and Service Stand (Part# TRACKL) readily available in order to complete these instructions...
- Page 2 INSTRUCTIONS CONTINUED 6) Remove the two #2 Phillips Head Screws from the AXS Securing Bracket in rear of rack (2 Places). AXS SECURING BRACKET 7) Cut the Wire-Ties holding the two Cable Carriers in place. CABLE CARRIER WIRE TIE 8) Loosen 7/16" bolt holding AXS Securing Bracket in place. Slide Bracket forward and remove. NOTE: Slide out rack for better access to Securing Bracket.
Need help?
Do you have a question about the MRK AXS Series and is the answer not in the manual?
Questions and answers