Figure 40 Lowering Ec Fans Into Floor Stand, Steps 7 Through 9 - Emerson Liebert DS Series User Manual

7. Using the jack, lower the fan module slowly until it rests on the frame of the unit.
NOTICE
Risk of equipment snagging cables and wiring. Can damage the Liebert DS components.
Monitor the position of the fan harnesses and other parts while lowering the fan to be sure
that they are not caught or pinched.
8. Secure the fan module in the fully lowered position by re-installing the hex head screws directly to
the frame. Screw clearance holes are provided in the fan module.
NOTE
Not all hardware retained will be used to secure the fans in the lowered positioned.
9. Repeat Steps 3 through 8 to lower remaining fan modules.

Figure 40 Lowering EC fans into floor stand, Steps 7 through 9

C
Use Removed
Hex Head Screws
to Secure Lowered
Fan to Frame
6
SECTION C-C
Fan Deck and Side Panels Not Shown
C
Lowered Fan
Module Resting
on Frame
Use Removed Hex
Head Screws to Secure
Lowered Fan to Frame
Z Brackets
(not present
on Liebert DS)
46
EC Fans—Lowering and Removing
Lower Fan
Module
Onto Frame
DPN002037
Page 2, Rev. 4