Ford Tourneo Connect Owner's Handbook Manual page 24

GENERALINFORMATIONON
RADIO FREQUENCIES
CAUTIONS
The radio frequency used by your
remote control can also be used by
other short distance radio
transmissions (e.g. amateur radios,
medical equipment, wireless headphones,
remote controls and alarm systems). If
the frequencies are jammed, you will not
be able to use your remote control. You
can lock and unlock the doors with the
key.
Check your vehicle is locked before
leaving it unattended. This will
safeguard against any potential
malicious frequency blocking.
Note: You could unlock the doors if you
press the buttons on the remote control
unintentionally.
The operating range between your
remote control and your vehicle varies
depending on the environment.
PROGRAMMING THE
REMOTE CONTROL
A maximum of four remote controls
(including any supplied with your vehicle)
can be programmed. The remote controls
must remain inside the vehicle during the
programming procedure. Fasten the front
seat belts and close all doors to ensure
that conflicting chimes do not sound
during programming.
Programming a new remote
control
1. To programme new remote controls
turn the ignition key to position II four
times within six seconds.
Keys and remote controls
2. Turn the ignition to position 0. A tone
sounds to indicate that it is now
possible to programme the remote
controls for ten seconds.
3. Press any button on a new remote
control. A tone will sound as
confirmation.
4. Repeat this last step for all your
remote controls, including your
original. Do not remove the key from
the ignition when pressing the button
on this remote control.
5. Switch the ignition back on (position
II) or wait for ten seconds without
programming another remote control
to end the key programming. Only the
remote controls which you have just
programmed are now able to lock and
unlock the vehicle.
Reprogramming the unlocking
function
Note: When you press the unlock button
either all the doors are unlocked or
depending on the locking configuration,
specific doors are unlocked. Pressing the
unlock button again unlocks all the doors.
Press and hold the unlock and lock
buttons on the remote key simultaneously
for at least four seconds with the ignition
off. The direction indicators will flash twice
to confirm the change.
To return to the original unlocking function,
repeat the process.
CHANGING THE REMOTE
CONTROL BATTERY
Make sure that you dispose of
old batteries in an
E107998
environmentally friendly way.
Seek advice from your local authority
regarding recycling.
22