Ford Tourneo Connect Owner's Handbook Manual page 119

GENERAL INFORMATION
CAUTIONS
Use only approved wheel and tyre
sizes. Using other sizes could
damage the vehicle and will make
the National Type Approval invalid.
If you change the diameter of the
tyres from that fitted at the factory,
the speedometer may not display
the correct speed. Take the vehicle to
your dealer to have the engine
management system reprogrammed.
A decal with tyre pressure data is located
in the driver's door opening at the B-pillar.
Check and set the tyre pressure at the
ambient temperature in which you are
intending to drive the vehicle and when
the tyres are cold.
CHANGING A ROAD WHEEL
Locking wheel nuts
You can obtain a replacement locking
wheel nut key and replacement locking
wheel nuts from your dealer using the
reference number certificate.
Vehicle jack
WARNINGS
Before using the vehicle jack, check
that it is not damaged or deformed
and that the thread is lubricated and
free from foreign matter.
Never place anything between the
jack and the ground, or the jack and
the vehicle.
It is recommended to use a workshop
type hydraulic jack for changing between
summer and winter tyres.
Wheels and tyres
Note: Use a jack with a minimum lifting
capacity of 1.5 tonnes and a lifting plate
with a minimum diameter of 80 millimetres
(3.1 inches).
Transit Connect
Your jack and wheelbrace are located in
the bag behind the driver's seat.
1. Move the driver's seat fully forwards
2. Fold the seatback fully forwards.
3. Open the retaining straps on the bag
4. Using the wheelbrace, remove the
E134540
5. Remove the jack.
6. Install in the reverse order.
Tourneo Connect
Your jack and wheelbrace are located in
the left-hand sidewall of the load area.
Jacking and lifting points
suspension, engine, braking system or
the fuel lines.
117
See Front seats (page 71).
and remove the wheelbrace.
retaining screw.
CAUTION
Use only the specified jacking points.
If you use other positions, you may
damage the body, steering,