Hilti GX 2 Original Operating Instructions page 23

3.11 Indication of battery charge status
After pressing a battery release button, the display shows the status of the battery and the fastening tool.
Status
All four LEDs light green.
Three LEDs light green.
Two LEDs light green.
One LED lights green.
One LED blinks green.
One LED blinks green.
4 Technical data
4.1 Fastening tool
Weight (empty)
Application temperature, ambient temperature
Maximum fastener length
Fastener diameter
Compression stroke
Magazine capacity in strips of 10 nails (Magazine capac-
ity)
Maximum fastener driving frequency (Fasteners per hour)
4.2 Noise information and vibration values
The sound pressure and vibration values given in these instructions have been measured in accordance
with a standardized test and may be used to compare one fastening tool with another. They may be used
for a preliminary assessment of exposure. The data given represents the main applications of the fastening
tool. However, if the fastening tool is used for different applications, with different accessories or is poorly
maintained, the data may vary. This may significantly increase exposure over the total working period. An
estimation of the level of exposure should also take into account the periods of time when the tool is not
actually in use. This may significantly reduce exposure over the total working period. Prescribe additional
safety measures to protect the operator from the effects of noise and/or vibration, such as: maintenance of
the direct fastening tool and its additional equipment or accessories, keeping the hands warm, organization
of work patterns.
Noise emission values determined in accordance with EN 15895
Emission sound pressure level at the workplace
(L )
pA, 1s
Peak sound pressure level at the workplace (L
Sound (power) level (L
Sound level uncertainty
Recoil
Energy-equivalent acceleration, (a
Uncertainty
5 Loading the fastening tool
5.1 Equipment required for driving nails
Nails are fed through the magazine in strip form (ready-to-use strips of nails).
Printed: 03.03.2017 | Doc-Nr: PUB / 5336064 / 000 / 00
)
WA, 1s
)
hw, RMS(3)
Meaning
• Charge status is 75 % to 100 %.
• Charge status is 50 % to 75 %.
• Charge status is 25 % to 50 %.
• Charge status is 10 % to 25 %.
• Charge status is below 10 %. The fastening tool
is ready for operation.
• The fastening tool is overloaded or overheated
and thus not ready for operation.
3.9 kg
−10 ℃ ... 45 ℃
39 mm
• 2.6 mm
• 3.0 mm
20 mm
1 ... 4
1,200
96 dB(A)
) 130 dB (C)
pC, peak
100 dB(A)
2 dB(A) / 2 dB(C)
Results for 1 mm sheet metal on C40 con-
crete: 3.69 m/s
2
0.22 m/s²
English 19