Table of Contents
Advertisement
Remote Node Setup
Follow the procedure in Chapter 5 to fill the protocol-independent
parameters in Menu 11, Remote Node Profile. For the protocol-
dependent parameters, follow the ensuing instructions.
1. Route - Make sure IPX is among the protocols in the Route field.
2. Edit IP/IPX/Bridge - Press the space bar to change it to Yes and
press Enter to go to the network layer options menu.
Figure 7-4 Menu 14.1 - Edit Dial-in User
3. Rem LAN Net # - In this field, enter the internal network number
of the NetWare server on the remote side LAN. Your Prestige will
create a route to access this server.
4. My WAN Net # - In this field, you can enter the WAN network
number of the device that you are connecting to. This number will
be used for negotiation between your Prestige and the remote
device. If you leave this field as 00000000, your Prestige will select
the greater WAN network number between the two devices.
5. Hop Count - This field indicates the number of intermediate
networks that must be passed through to reach the Remote Node.
The default is one (1).
Novell IPX Configuration 57
Advertisement
Table of Contents
