Table 34 Firewall: Edit Rule - ZyXEL Communications P-660H-D Series User Manual

Table 34 Firewall: Edit Rule

LABEL
Active
Action for Matched
Packet
Source/Destination
Address
Address Type
Start IP Address
End IP Address
Subnet Mask
Add
Edit
Delete
Services
Available/ Selected
Edit Customized
Schedule
Day to Apply Select everyday or the day(s) of the week to apply the rule.
Time of Day to
Apply (24-Hour
Log
Log Packet Detail
Information
Alert
Send Alert Message
to Administrator
When Matched
Back
Apply
Cancel
Delete
Chapter 11 Firewall Configuration
DESCRIPTION
Select this option to enable this firewall rule.
Use the radio button to select whether to discard (Block) or allow the passage of
(Forward) packets that match this rule.
Do you want your rule to apply to packets with a particular (single) IP, a range of
IP addresses (e.g., 192.168.1.10 to 192.169.1.50), a subnet or any IP address?
Select an option from the drop-down list box that includes: Single Address,
Range Address, Subnet Address and Any Address.
Enter the single IP address or the starting IP address in a range here.
Enter the ending IP address in a range here.
Enter the subnet mask here, if applicable.
Click Add to add a new address to the Source or Destination Address box.
You can add multiple addresses, ranges of addresses, and/or subnets.
To edit an existing source or destination address, select it from the box and click
Edit.
Highlight an existing source or destination address from the Source or
Destination Address box above and click Delete to remove it.
Please see Section 11.10 on page 126
Services available. Highlight a service from the Available Services box on the left, then
click Add>> to add it to the Selected Services box on the right. To remove a
service, highlight it in the Selected Services box on the right, then click
Remove.
Click the Edit Customized Services link to bring up the screen that you use to
Service configure a new custom service that is not in the predefined list of services.
Select All Day or enter the start and end times in the hour-minute format to apply
the rule.
Format)
This field determines if a log for packets that match the rule is created (Enable)
or not (Disable). Go to the Log Settings page and select the Access Control
logs category to have the Prestige record these logs.
Select the check box to have the Prestige generate an alert when the rule is
matched.
Click Back to return to the previous screen.
Click Apply to save your customized settings and exit this screen.
Click Cancel to exit this screen without saving.
Click Delete to remove this firewall rule and return to the Firewall Rule
Summary screen.
P-660R/H-D Series User's Guide
for more information on services
120