Table 145 Tcp Reset Logs; Table 146 Packet Filter Logs - ZyXEL Communications P-660H-D Series User Manual

Table 145 TCP Reset Logs

LOG MESSAGE
Under SYN flood attack,
sent TCP RST
Exceed TCP MAX
incomplete, sent TCP RST
Peer TCP state out of
order, sent TCP RST
Firewall session time
out, sent TCP RST
Exceed MAX incomplete,
sent TCP RST
Access block, sent TCP
RST

Table 146 Packet Filter Logs

LOG MESSAGE
[TCP | UDP | ICMP | IGMP |
Generic] packet filter
matched (set:%d, rule:%d)
Appendix M Log Descriptions
DESCRIPTION
The router sent a TCP reset packet when a host was under a SYN
flood attack (the TCP incomplete count is per destination host.)
The router sent a TCP reset packet when the number of TCP
incomplete connections exceeded the user configured threshold.
(the TCP incomplete count is per destination host.) Note: Refer to
TCP Maximum Incomplete in the Firewall Attack Alerts screen.
The router sent a TCP reset packet when a TCP connection state
was out of order.Note: The firewall refers to RFC793 Figure 6 to
check the TCP state.
The router sent a TCP reset packet when a dynamic firewall
session timed out.
The default timeout values are as follows:
ICMP idle timeout: 3 minutes
UDP idle timeout: 3 minutes
TCP connection (three way handshaking) timeout: 270 seconds
TCP FIN-wait timeout: 2 MSL (Maximum Segment Lifetime set in
the TCP header).
TCP idle (established) timeout (s): 150 minutes
TCP reset timeout: 10 seconds
The router sent a TCP reset packet when the number of
incomplete connections (TCP and UDP) exceeded the user-
configured threshold. (Incomplete count is for all TCP and UDP
connections through the firewall.)Note: When the number of
incomplete connections (TCP + UDP) > "Maximum Incomplete
High", the router sends TCP RST packets for TCP connections
and destroys TOS (firewall dynamic sessions) until incomplete
connections < "Maximum Incomplete Low".
The router sends a TCP RST packet and generates this log if you
turn on the firewall TCP reset mechanism (via CI command: "sys
firewall tcprst").
DESCRIPTION
Attempted access matched a configured filter rule (denoted by
its set and rule number) and was blocked or forwarded
according to the rule.
P-660R/H-D Series User's Guide
398