Led A And Led B Status Display; Operation; Connection Diagram - Bosch KTS Truck Original Instructions Manual

en 14 | KTS Truck |
3.4.3

LED A and LED B status display

Status
KTS Truck starts up
KTS Truck ready for operation Off
Data communication with
control unit
Firmware deletion (progress
bar 0%, duration: approx.
3 seconds)
Firmware update – Part 1
(progress bar 0% – 90%, dura-
tion: approx. 30 minutes)
Firmware update – Part 2
(progress bar 91 % – 100 %,
duration: ca. 5 minutes)
Status LED A
No voltage Off
supply
Firmware up- Flashing red
date problem (0.5 second
frequency)
Voltage supply Off
> 37 V
Unplug USB connection and power supply and plug in again.
1)
Contact customer service if the problem persists.
3.5

Operation

KTS Truck must be connected to a PC/Laptop by way of
Bluetooth or the USB interface.
!
Do not subject the Bluetooth USB adapter connec-
ted to the laptop to mechanical strain or use it as a
handle, as this could damage the Laptop or Bluetooth
USB adapter.
i
The Bluetooth connection between KTS Truck and the
PC/Laptop can be established using the Bluetooth
USB adapter included in the scope of delivery (for
PC/Laptop without internal Bluetooth hardware).
i
For information on Bluetooth and Bluetooth symbol,
see online help for ESI[tronic] 2.0 by selecting
|
1 689 989 100 2018-01-24
LED A LED B
Off Glows red (for
10 seconds)
Flashing green
(1 second fre-
quency)
Flashing green Flashing green
(irregular) (1 second fre-
quency)
Flashing red Flashing
(rapid) green/yellow
(quick)
Flashing red Flashing
(0.5 second green/yellow
frequency) (0.5 second
frequency)
Off Flashing red
(1 second fre-
quency)
LED B Measure
Off Check the vol-
tage supply
Flashing Repeat firm-
1)
green/yellow ware update
(0.5 second
frequency)
Flashing yellow
1)
(1 second fre-
quency)
3.5.1

Connection diagram

1
11
DCU 130
10
8
9
Abb. 3: Connection diagram KTS Truck
1 Connecting tip from universal connection set
2 OBD interface in vehicle
3 Vehicle-specific adapter cable (special accessory)
4 OBD diagnostic cable
5 Universal adapter cable
6 PC/laptop (e. g DCU 220)
7 KTS Truck
8 Adapter cable with battery clips (with fuse 3 AT)
9 Connection cable for cigarette lighter socket (with fuse 3 AT)
10 USB connection cable
11 Bluetooth USB adapter (only needed for PC/Laptop without
internal Bluetooth hardware)
!
Under no circumstances can the KTS Truck be
connected to a laptop via the USB connecting cable
if a power supply unit is connected via the cigarette
lighter socket of a vehicle and the laptop is powe-
red via this power supply unit. This can damage the
KTS Truck. In this case, communication between
the laptop and KTS Truck must be established via
. Bluetooth.
2
1
9
2
10
3
11
12 4
13 5
14
6
15
7
16
8
4
3
6
Powered by ESI[tronic]
7
Robert Bosch GmbH
5