Ip Static Route Edit; Figure 190 Ip Static Route Edit; Table 133 Ip Static Route Edit - ZyXEL Communications 35 Series User Manual

Internet security appliance

Table of Contents

Table 132 IP Static Route

23.2.1 IP Static Route Edit

Select a static route index number and click Edit. The screen shown next appears. Use this

screen to configure the required information for a static route.

The following table describes the labels in this screen.

Destination IP

IP Subnet Mask

Chapter 23 Static Route

This field shows whether this static route is active (Yes) or not (No).

This parameter specifies the IP network address of the final destination. Routing is

always based on network number.

This is the IP address of the gateway. The gateway is a router or switch on the same

network segment as the device's LAN or WAN port. The gateway helps forward

packets to their destinations.

Click the edit icon to go to the screen where you can set up a static route on the

Click the delete icon to remove a static route from the ZyWALL. A window displays

asking you to confirm that you want to delete the route.

Enter the name of the IP static route. Leave this field blank to delete this static route.

This field allows you to activate/deactivate this static route.

This parameter specifies the IP network address of the final destination. Routing is

always based on network number. If you need to specify a route to a single host, use

a subnet mask of 255.255.255.255 in the subnet mask field to force the network

number to be identical to the host ID.

Enter the IP subnet mask here.

ZyWALL 5/35/70 Series User's Guide

Table of Contents