Weighing Your Food - Gastroback Design Vacuum Sealer Advanced Scale Pro Operating Instructions Manual

WEIGHTING YOUR FOOD
Tip: The scale can display the weight in several units. After disconnecting the
appliance from the power supply, the unit grams ("g") will always be selected.
However, as long as the appliance is live, the recently selected unit will be kept
in memory (see: 'Units of Weight').
To ensure an accurate result (e.g. for weighing spices), wait at least 30 seconds
after connecting the appliance to the power supply, before you place any items
on the scale platform.
CAUTION:
enter calibration mode and, without any load on the scale platform, the LCD dis-
play shows "2000.0 g". In this case, immediately press the STOP button to
cancel calibration mode. The scale is factory calibrated. Usually, there is no need
to repeat calibration, but with an imperfect or erroneous calibration, all following
readings will be incorrect (see: 'Calibration').
Important: During weighing, ensure not to touch the contact bar on the lid of
the appliance. Otherwise, the lid of the appliance would open and the objects
on the scale platform could fall down. The lid of the appliance must be closed
for weighing.
1. Prepare the scale for operation (see: 'Preparing the Scale for Operation').
2. If the desired unit is not indicated on the rightmost column of the LCD display,
press the MODE button repeatedly until the desired unit is shown.
CAUTION:
scale platform. Always place the objects to be weighed on the centre of the
scale platform to avoid damage to the scale sensor. After activating the tare
function by pressing the TARE button, keep in mind that the total weight of the ves-
sel/packaging plus contents may not exceed 2 kg. If in doubt, check the weight
using another course scale. If required, weigh your food in portions.
3. Place the objects to be weighed on the centre of the scale platform. On the LCD
display the weight is shown.
4. Remove the objects from the scale platform immediately after weighing, to
maintain the accuracy of the scale sensor.
By pressing the MODE and TARE buttons simultaneously, you
Do not place any objects weighing more than 2 kg onto the
77