Temporary Temperature Forcing; Reset And Reinstatement Of Default Settings - Gewiss GW 10 793 Manual

In Economy, Precomfort and Comfort operating modes or in Master/Slave with set point
control mode, the active temperature set point can be temporarily forced using the
keys to set the desired value. Confirm the value by pressing the
for 5 seconds.

Reset and reinstatement of default settings

Press the FAN and SET keys together for 2 seconds, when the device is powered by the
bus, to reset the thermostat.
Caution: all the previously set parameters will be cancelled.
When it is turned back on, the thermostat will use the default factory settings. The
thermostat will be set to heating in OFF mode.
OPERATING INSTRUCTIONS
P15 - Enable remote control mode and operation type
settings
When P15 appears, enable or disable remote controls using
the keys.
(OFF = remote controls OFF, ON = remote controls ON)
The symbol
enabled.
When the remote control option is enabled it is possible to
remotely set the operation type and mode, for instance
using the EIB GSM remote control unit (GW 90 815).
The programming phase is now complete Press the SET key
to return to normal operation mode.

Temporary temperature forcing

, or
that forcing is enabled.
For Slave control mode, set point temperature variation is
limited by the P14 - Set point variation interval for
manual override parameter value.
on the display indicates that this option is
or blink on the screen to indicate
55
E
N
G
L
I
S
H
key or waiting