ZyXEL Communications omni.net LCD+M Technical Reference page 161

All the Following Commands Require a 'AT' Prefix
S Com. bit dec hex
S29= 0-39 0-39
S31= 0-25 0-FF
5
S32= 0-25 0-FF
5
S35= bit dec hex
6 64 30
7 128 60
S36= bit dec hex
5-7
0 (*) 0
32 20
64 40
96 60
128 80
160 A0
S38= bit dec hex
0 1 1
1-2
2 4 4
3 8 8
S40= bit dec hex
1 2 2
Technical Reference for ZyXEL omni.net series
Function and description
Set default dial phone number pointer, use 'AT&Zn=s' to
store phone numbers.
Holds the ASCII decimal value of the XON.
Holds the ASCII decimal value of the XOFF.
Bit mapped register
Enable password protection to profile saving, when
<AT&Wn> is issued, and the 'n' profile in the memory has
this bit on, supervisory password will be requested.
Enable extended numerical result codes from 50-71 when
an error corrected connection is made. Use with 'ATV0' (see
result code table).
Bit mapped register
Security function control register
Disable security function.
Enable type 1 security, with password check (Proprietary).
Enable type 1 security, with password check and callback
(Proprietary).
Enable type 2 security, with password check.
Enable type 2 security, with password check and callback.
Enable type 2 security, with password check and callback.
Remote site enters the callback number.
Bit mapped register
Repeatedly dialing default number.
Reserved.
Key for ATSWR, ATHWR.
DCD on/off sequence follows UNIX standard, DCD high
before connect message is sent, DCD off after last DCE
response is sent.
Bit mapped register
No result code displayed in answer mode.
+Def./Ref.
+000 *D
+017
+019
&Wn
V0
S23b6
+000
*G0
*G1
*G2
*G3
*G4
*G5
+000
*Dn, S29
&C1 S21b4
+000
Q2
B-9