Installation - Slot Mount Tt Hardware - Permobil Comfort M2 BodiLink LPTS Operation Manual

INSTALLATION - SLOT MOUNT TT HARDWARE

Attaching TT hardware to the Comfort Company solid seat support base. All required tools are provided.
1
Remove the screws (A), safety washers (B), flat
washers (C), double washer (D), and double nut (E)
from the TT hardware assembly (F), using the 5mm
hex key. Retain the fasteners for re-assembly.
2
Set the hardware assembly (F) on top of the seat
support base (G) in the desired location, making sure
the slot in the assembly base (F) aligns with two of the
slots on the seat support base (G), as shown.
For removable hardware, the silver release lever (not
pictured) is intended to face the front of the wheelchair.
3
Replace the double nut (E) in the top of the slot on (F).
4 Replace the screws (A), safety washers (B), flat
washers (C), and double washer (D) from below the
seat support base (G). Note: The squares on (D) should
fit into the slots on (G). Do not fully tighten the screws to
allow further/final adjustments.
5
Continue with pad and hardware ADJUSTMENT and USE
instructions in this manual.
Fixed TT Hardware Shown
BodiLink Lateral Trunk Support Operation Manual
A
8
F
D
C
B
A
E
D
C
B
E
G
F