Ip Address And Subnet Mask; Ip Address Assignment; Figure 6 Internet Access Wizard Setup: First Screen; Table 4 Internet Access Wizard Setup: First Screen - ZyXEL Communications Network Adapter P-660RU-T V2 User Manual

Figure 6 Internet Access Wizard Setup: First Screen

The following table describes the labels in this screen.

Table 4 Internet Access Wizard Setup: First Screen

LABEL
Mode
Encapsulation
Multiplex
Virtual Circuit
ID
VPI
VCI
Next

3.2 IP Address and Subnet Mask

See Appendix C on page 141

3.2.1 IP Address Assignment

A static IP is a fixed IP that your ISP gives you. A dynamic IP is not fixed; the ISP assigns you
a different one each time. The Single User Account feature can be enabled or disabled if you
have either a dynamic or static IP. However the encapsulation method assigned influences
your choices for IP address and ENET ENCAP gateway.
P-660RU-T v2 User's Guide
DESCRIPTION
From the Mode drop-down list box, select Routing (default) if your ISP allows
multiple computers to share an Internet account. Otherwise select Bridge.
Select the encapsulation type your ISP uses from the Encapsulation drop-down list
box. Choices vary depending on what you select in the Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC 1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or
PPPoE.
Select the multiplexing method used by your ISP from the Multiplex drop-down list
box either VC-based or LLC-based.
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit.
Refer to the appendix for more information.
Enter the VPI assigned to you. This field may already be configured.
Enter the VCI assigned to you. This field may already be configured.
Click this button to go to the next wizard screen. The next wizard screen you see
depends on what protocol you chose above. Click on the protocol link to see the next
wizard screen for that protocol.
for background information on IP addresses and subnetting.
Chapter 3 Wizard Setup
39