Testing; Deactivation And Setting Aside - Automatic Systems ClearLock 645 User Manual

6. Start the booth with the ignition key placed on the console or with the key placed on the external side of the
booth. Wait approximately 10 seconds, during which do not touch the doors, so to avoid calibration changes.
7. Now the booth is ready to be tested (this must to be carried out by authorized staff only) and ready for use.

3.7. Testing

Once tested, verify:
• Control that the console is working.
• Metal detector alarm.
• CE release button.
• Photoelectric cells working.
• Check door's movements.
• Check the automatic reset.
• Check the signal lights.
For settings different from those pre-set, ask

3.8. Deactivation and setting aside

If the booth is not used for a long time, it is necessary to disconnect the power supply cable and the batteries.
We exhort the operator to put away the booth in a dry and sheltered place and to insulate every com- ponent
from the floor and walls.
REMEMBER THAT ONLY SKILLED AND AUTHORIZED STAFF CAN DISASSEMBLE THE SYSTEM.
The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using this information for any purpose other
than the use of the products or the execution of the project to which it refers and from communicating it to third parties without prior written agreement of Automatic Systems.
The document is subject to change without notice.
ClearLock 645
-UM-EN
Automatic Systems for the technical handbooks.
p. 19 / 28