System Installation; Preliminary Checks; Unpacking - Automatic Systems ClearLock 645 User Manual

3. SYSTEM INSTALLATION

3.1. Preliminary checks

Before installing the booth, it is necessary to check the following very carefully, in order to avoid
possible failures.
N.B. Possible floor defects can cause an incorrect working of the system.
- Make sure that the booth can be carried in a vertical position to the desired place.
N.B.: When moving, avoid stresses on the Metal Detector's columns.
The booth cannot be reduced in dimensions, but it can be carried in an horizontal position for a short way,
then restore it to its vertical position.
N.B.: Moving the booth can cause mechanical damages. We suggest that only skilled and equipped staff do
the job.
Inform Automatic Systems when this operation is necessary.
- Verify that the ceiling of the location area is, at least, 280 cm high (every booth is 236 cm high). This will
guarantee the entry into the upper part of the system and to carry out the assembly and the maintenance
operations of the booth.
- Verify that disturbance sources do not cause metal detector failures (see the paragraph about "Metal Detector
disturbance sources" further on in this chapter).
N.B: For the Metal Detector to work correctly, it is important that the surrounding area re- mains the same
and does not change in time.

3.2. Unpacking

After the unpacking operations, make sure that all the booth's components are complete. See if there are any
visibly damaged parts. In case of doubts, contact Automatic Systems directly.
PACKING PARTS (SUCH AS PLASTIC BAGS, FOAM POLYSTYRENE, NAILS, SCREWS, WOOD ETC.) MUST BE KEPT
AWAY FROM CHILDREN'S REACH, AS THEY CAN BE EXTREMELY DANGEROUS.
Collect the above mentioned materials in special dumps.
The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using this information for any purpose other
than the use of the products or the execution of the project to which it refers and from communicating it to third parties without prior written agreement of Automatic Systems.
The document is subject to change without notice.
ClearLock 645
-UM-EN p. 12 / 28