Automatic Systems ClearLock 645 User Manual page 11

The use of the main panel switch must be used only for emergencies since
it can ruin the batteries and will need to be substituted if they do not re-charge.
Stop button inside the booth. (Detail n°9 fig. 2).
If the stop function is turned on when the doors are moving, it will allow only to open the doors manually.
If the stop function is turned on when both doors are closed, the external door's brake releases, and the
movements of the doors are blocked.
To restore the booth's standard operation, it is necessary to reset it.
Passage authorization.
Should undesired people be recognized or if there is the necessity to interrupt the entrance's passage,
it can be done by switching to the OFF position the command on the console (fig. 1A).
To restore the normal passage switch to the ON position.
Booth does not function properly.
Should there be problems with the booth's functions verify that the controls on the console are switched to
NORMAL TRANSIT before you do other checks. Unstable current or a long period without power supply can
cause problems to the booth, simulating for example, the presence of an object.
To restore the booth to normal working condition, switch OFF the booth on the main console, wait a few
seconds and then turn it on again.
In case of a blackout or if the batteries have run out it is possible to open the doors as described in the
emergency procedure.
Should these malfunctions persist or should problems arise different from those described, please call our
maintenance service:
The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using this information for any purpose other
than the use of the products or the execution of the project to which it refers and from communicating it to third parties without prior written agreement of Automatic Systems.
The document is subject to change without notice.
ClearLock 645
-UM-EN p. 11 / 28