Repairs - Silver Fox Avant Owner's Manual

7 REPAIRS

In case of engine or equipment failure, contact the respective
supplier.
Minor surface (gelcoat) damage on the hull and deck can be re-
paired by the owner himself. However, doing a good job requires
skill and effort:
− tape the surface around the damaged spot to protect it
− grind the perimeter of the dent to remove sharp edges and
degrease with acetone
− mix 1.5 to 2.0 % of hardener in the gelcoat
− apply the gelcoat to the spot to be repaired so that it remains
slightly higher than the surrounding area
− attach a tape carefully over the repaired spot
− after the gelcoat has cured, remove the tape and sand the
repaired spot flush if necessary to make it neat
− polish the repaired spot with a polishing paste.
The colour scheme of the boat and more detailed instructions for
making repairs are available from the boatyard or your gelcoat dealer.
When fitting new accessories, etc., to the boat, use only aluminium
or acid resistant steel rivets and screws. Isolate all equipment made
of metals other than aluminium from the hull and aluminium parts.
CAUTION!
Certain retro-fittings and modifications may, if not
correctly performed, damage the boat and compro-
mise safety. Contact the manufacturer or some oth-
er authorised yard before making new grounding
connections, hatches, etc., or hiring somebody else
to do it.
CAUTION! Always switch off the current before any work on
electrical equipment. If you need to replace any
electrical components, make sure that they are
compatible with the onboard voltage.
CAUTION! Tape that will be applied on the side striping can
harm the original tape surface. Please make sure
that the material will comply.
133