ZyXEL Communications OMNI 56K Plus Series User Manual page 39

Table 4-9 Supported Commands (per TIA PN2388 8/20/90)
COMMAND
+FDR Receive phase C data command; initiates document reception.
+FDT=df,vr,wd, ln Transmit phase C data command: release the DCE to proceed with
negotiation.
+FET=n End of page or document command:
More pages; same document.
End of document; another document follows.
No more pages or documents.
Procedure interrupt; another page follows.
Procedure interrupt; end of document, another document follows.
Procedure interrupt; end of document.
+FK Regular fax abort command.
+FLID="string" Local ID string parameter.
+FLO=n Flow control options:
No flow control.
Set XON/XOFF software flow control.
Set CTS/RTS hardware flow control.
+FLPL=n Document for polling command:
The DTE has no document available for polling.
Indicate a document available for polling.
+FMDL? Request DCE model.
+FMFR? Request DCE manufacturer.
+FMINSP=n Minimum phase C speed parameter:
2400 bps.
4800 bps.
7200 bps.
9600 bps.
12000 bps.
14400 bps.
+FPHCTO= DTE Phase C response time-out:
<value> Determine how long the DCE will wait for a command after reaching
the end of data when transmitting in Phase C.
<value>=0 to 255; 100 ms units.
+FPTS=n Page transfer status
Received page good.
Page bad; retrain requested.
Page good; retrain requested.
Command Sets
Omni 56K Plus Series User's Guide
DESCRIPTION VALUE
n=0
n=1
n=2
n=4
n=5
n=6
n=0
n=1
n=2
n=0
n=1
n=0
n=1
n=2
n=3
n=4
n=5
0-255
n=1
n=2
n=3
4-11