ZyXEL Communications OMNI 56K Plus Series User Manual page 38

Omni 56K Plus Series User's Guide
Table 4-9 Supported Commands (per TIA PN2388 8/20/90)
COMMAND
Only check 1D phase C data.
Check both 1D and 2D phase C data.
+FCR=n "Capability to receive" parameter
DCE will not receive message data or poll a remote device.
DCE receives message data or polls a remote device.
+FDCC=vr,br,wd,ln,d DCE capabilities parameters.
f,ec,bf,st
Vertical resolution: Normal; 98 lpi.
Vertical resolution: Fine; 196 lpi.
Bit rate: 2400 bit/s; V.27ter.
Bit rate: 4800 bit/s; V.27ter.
Bit rate: 7200 bit/s; V.29 or V.17.
Bit rate: 9600 bit/s; V.29 or V.17.
Bit rate: 12000 bit/s; V.17.
Bit rate: 14400 bit/s; V.17.
Page width: 1728 pixels in 215mm.
Page width: 2048 pixels in 255mm.
Page width: 2432 pixels in 303mm.
Page length: A4; 297mm.
Page length: B4; 364mm.
Page length: unlimited length.
Data compression format: 1-D; modified Huffman.
Data compression format: 2-D; modified Read.
Error correction disabled.
Disable binary file transfer.
Minimum scan time/line: 0 ms.
Minimum scan time/line: 5 ms.
Minimum scan time/line:10 ms (normal); 5 ms (fine).
Minimum scan time/line:10 ms.
Minimum scan time/line:20 ms (normal); 10ms (fine).
Minimum scan time/line:20 ms.
Minimum scan time/line:40 ms (normal); 20ms (fine).
Minimum scan time/line:40 ms.
+FDCS=vr,br,wd,ln,d Current session parameter; refer to +FDCC command.
f,ec,bf,st
+FDIS=vr,br,wd,ln,df, Current session negotiation parameter; refer to +FDCC command.
ec,bf,st
4-10
DESCRIPTION VALUE
n=1
n=2
n=0
n=1
vr=0
vr=1
br=0
br=1
br=2
br=3
br=4
br=5
wd=0
wd=1
wd=2
ln=0
ln=1
ln=2
df=0
df=1
ec=0
bf=0
st=0
st=1
st=2
st=3
st=4
st=5
st=6
st=7
Command Sets