ZyXEL Communications OMNI 56K Plus Series User Manual page 52

Omni 56K Plus Series User's Guide
COMMAND BIT
7 0
128
S29= 0-49
S31= 0-255
S32= 0-255
S35= bit dec
1 2
3 8
5 32
7 128
S38= bit Dec
0 1
3 0
3 8
4 16
5 32
S39= bit dec
2 4
3 8
4 16
5 32
S40= bit dec
1 2
2 4
3 8
4 16
5 32
4-24
Table 4-16 Extended S-Registers "ATSn=x"
DEC HEX
0 Select V.22 for 1200 bps communication
80 Select Bell 212A for 1200 bps communication
0-31 Set default dial phone number pointer, use AT&Zn=s to
store phone numbers in EEPROM.
0-FF Holds the ASCII decimal value of the XON .
0-FF Holds the ASCII decimal value of the XOFF.
hex Bit mapped register.
2 Disable aborting from terminal during modem
handshaking.
8 Add 16dB attenuation to the leased line transmission
power.
20 Enable Selective Reject in V.42. (Default)
80 Enable extended numerical result codes from 50-65
when an error corrected connection is made. Use with
ATV0. (see result code table)
hex Bit mapped register.
1 Repeatedly dialing default number if not connected.
0 CD tracks the carrier. (Default)
8 DCD ON/OFF sequence follows UNIX standard, DCD
ON before connect message is sent, DCD off after last
DCE response is sent.
10 Auto-mode fax receiving disabled, hang up if a fax call
is received.
20 Disable MNP5 negotiation.
hex Bit mapped register.
4 Reverse the answers. Answer in originating mode.
8 Class 2 Fax Bitfax compatibility:
+FCON at 2400; next phase at 19200
10 Class 2 Fax mode DTE shifting:
+FCON at current DTE rate, shift to 19,200 when
entering into the next phase
20 Disable srambler/descrambler in V.26bis mode.
Enables compatibility with older V.26bis modems which
have no such unit (Default)
hex Bit mapped register.
2 No result code is displayed in answer mode.
4 Enables caller ID detection.
8 Enables type 1 ring detection.
10 Enables type 2 ring detection.
20 Enables type 3 ring detection.
FUNCTION AND DESCRIPTION REF.
B0*
B1
+000 *D
+017
+019
+032
*
V0
S23.6
+000
*Dn, S29
&C0
&C1,
S21.4
&N0
&Kn
+032
ATA
*
+000
Q2
Command Sets