Safety Information - Cypress PSoC 4100S Plus Manual

Safety Information

Regulatory Compliance
The CY8CKIT-149 PSoC 4100S Plus Prototyping Kit is intended for use as a development platform
for hardware or software in a laboratory environment. The board is an open system design, which
does not include a shielded enclosure. This may cause interference to other electrical or electronic
devices in close proximity. In a domestic environment, this product may cause radio interference. In
such cases, you may be required to take adequate preventive measures. In addition, this board
should not be used near any medical equipment or RF devices.
Attaching additional wiring to this product or modifying the product operation from the factory default
settings may affect its performance and cause interference with other apparatus in the immediate
vicinity. If such interference is detected, suitable mitigating measures should be taken.
CY8CKIT-149 PSoC® 4100S Plus Prototyping Kit Guide, Doc. #: 002-20729 Rev. *E
The PSoC 4100S Plus Prototyping Kit, as shipped from the
factory, has been verified to meet with requirements of CE as a
Class A product.
The CY8CKIT-149 PSoC 4100S Plus Prototyping Kit contains
electrostatic discharge (ESD) sensitive devices. Electrostatic charges
readily accumulate on the human body and any equipment, and can
discharge without detection. Permanent damage may occur on devices
subjected to high-energy discharges. Proper ESD precautions are
recommended to avoid performance degradation or loss of functionality.
Store unused CY8CKIT-149 PSoC 4100S Plus Prototyping Kit boards in
the protective shipping package.
End-of-Life/Product Recycling
This kit has an end-of life five years from the date of manufacture
mentioned on the back of the box. Contact your nearest recycler for
discarding the kit.
5