Fuel System; Brake (= Option) Adjustment; Brake Shoe Adjustment - Atlas Copco XA186 Dd Instruction Manual

Portable compressor
Hide thumbs Also See for XA186 Dd:
Table of Contents

Advertisement

5.5
F
UEL SYSTEM
Fig. 5.4
Fuel filter
Replacing the filter element
1. Unscrew the filter element (1) from the adapter head.
2. Clean the adapter head sealing surface. Lightly oil the gasket of
the new element and screw the latter onto the header until the
gasket is properly seated, then tighten with both hands.
3. Check for fuel leaks once the engine has been restarted.
5.6
B
RAKE
Before jacking up the compressor, connect it to a towing
vehicle or attach a weight of minimum 50 kg to the
towbar.
5.6.1 B
RAKE SHOE ADJUSTMENT
Check the thickness of the brake lining. Remove both black plastic
plugs (5). When the brake lining has been worn to a thickness of
1 mm or less, the brake shoes have to be replaced. After inspection
and/or replacement re-insert both plugs.
1
Fig. 5.5

Brake shoe adjustment

1
Adjusting bolt
2
Axle
3
Brake cable
4
Pin ¿ 4 mm
5
Plug
Brake shoe adjustment re-establishes the brake lining-to-drum
clearance and compensates for lining wear.
Lift and support the compressor. Make sure that all brakes are off
(overrunbrake and hand brake lever). The brake cables must be free
from tension. Lock the swivel cams of the wheel brake from the
outside by means of a pin ¿ 4 mm (4) through the hole as shown in
Fig. 5.5.
Turn the adjusting bolt (1) clockwise with a wrench till the wheel
locks up. Center the brake shoes by actuating the parking brake
several times.
Turn the adjusting bolt anti-clockwise until the wheel is running free
in direction of travel (approx. 1 full turn of the adjusting bolt).
Check the position of the equalizer (Fig. 5.7, 6) with the parking
brake actuated.
Perpendicular position of equalizer = identical clearance of wheel
brakes.
Re-adjust the brake shoes, if necessary.
To test, slightly apply the parking brake and check identical brake
torque on left and right side.
Remove locking pin (4). Remove clearance from brake cables.
Check all lock nuts (Fig. 5.7, 2).
I
NSTRUCTION
(=
)
OPTION
ADJUSTMENT
4
5
1
3
2
M
ANUAL
23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xahs146 ddXas186 ddXavs136 ddXats156 dd

Table of Contents