Table Of Contents - ETC Sensor+ SR Series Retro-Fit Manual

S a f e t y
Please note the following safety warnings before use:
• Disconnect power from the racks before all maintenance.
W A R N I N G :
O v e r v i e w o f t h i s M a n u a l
Reference this manual throughout the retrofit procedure.
• Preparation, page 5
• Remove the Old, page 5
• Install the New Backplane, page 9
• Change out the AF Cards (if present), page 10
cards and install the new ones.
• Change out the Beacon PCB, page 10
• Verify the Retrofit, page 11
• Configure the CEM+, page 11
• Finishing Touches, page 11
• Quick Reference Sheet, page 13
When viewing this document in electronic form (pdf file) with Adobe Acrobat Reader, blue
italicized text followed by a page number such as
link within the document. If you click on the link, it will jump to that section or topic.
2
Dimmer racks without an accessible power disconnect device cannot be
serviced safely.
- before you open the rack.
- labeling and remove the existing equipment.
- put the dimmers back in the rack and power up the rack.
- transfer the wiring and install new components.
- remove the existing Advanced Feature
- replace the beacon pcb with the new one.
- put a configuration in the CEM+.
- replace rack stickers and the acrylic beacon in the door.
- is an illustrated overview of the retrofit procedure.
"Overview of this Manual, page 2" is a
CEM+ Sensor Rack Retrofit Manual