Advertisement
• Pacific
• Alaskan
• Hawaiian
3. Check that ATOMIC is ON. This must be ON to receive a WWVB atomic time signal.
4. Check that the DST indicator is ON. If the indicator is OFF your clock will not change into or
out of Daylight Saving Time.
5. Batteries dated earlier than 6 years from now may still work, but may be unstable in
performance.
Note: Without proper batteries, the antenna will have a harder time picking up the signal.
•
For information about WWVB visit:
Set Alarm Time:
1. Hold the ALARM button 3 seconds to enter alarm mode. The alarm HOUR will flash.
2. Press the + or - button to adjust the flashing values, hold to adjust quickly.
3. Press the ALARM button to confirm adjustments and the alarm MINUTES will flash.
4. Press the + or - button to adjust the flashing values, hold to adjust quickly.
5. Press the ALARM button to exit.
Activate or Deactivate alarm:
•
The alarm is active when set. From normal time display, press and release the ALARM button
to deactivate or activate the alarm.
•
Alarm icon (bell) will show then active.
Snooze:
•
When your alarm sounds, press the SNOOZE button to silence alarm for 10 minutes. The
alarm bell will flash.
•
Press any button except SNOOZE to silence the alarm for 24 hours.
FACTORY RESET: HOW DO I FACTORY RESET MY CLOCK?
•
A factory reset is a great way to return your clock to "out of the box" condition.
To factory reset your clock:
1. Remove batteries from your clock. Press any button on your clock 20 times to help
discharge collected power.
2. Wait 15 minutes then insert batteries into your clock and set time/date.
http://bit.ly/AtomicTime
HOW DO I SET ALARM TIME?
TROUBLESHOOTING
4 |
P a g e
Hide quick links:
Advertisement
