Advertisement
Loss of WWVB signal, follow these steps:
1. Check for a Tower Icon showing on the display near the time. The tower icon indicates
successful reception of the WWVB signal in the past 24-hours.
2. Check that the Clock is in the correct Time Zone.
3. Check that ATOMIC is ON. This must be ON to receive a WWVB atomic time signal.
4. Check that the DST indicator is ON. If the indicator is OFF the clock will not change into or
out of Daylight Saving Time.
5. Position clock with front or back facing Fort Collins, Colorado so the widest part of the
antenna is positioned to receive.
For information about WWVB visit:
WHAT IS TIME ADVANCE AND HOW DO I SET IT?
Have your clock match other times around the world by setting a Desired Hour, kept accurate
by the Atomic Time Signal. Note: Only the hour can be changed.
Set Desired Hour:
1. Hold the TIME ADVANCE button until the Hour flashes, "Desired Hour" will show.
2. Press the + (PLUS) button to adjust the hour. Press the - (MINUS) button to reset hour to
"current hour".
3. Press the TIME ADVANCE button to confirm and exit.
Switch between Desired Time and Local time:
• Press the TIME ADVANCE button to switch between Desired Time and Local Time.
• Desired Time is indicated with the
Set Alarm:
1. Hold the ALARM button to enter Alarm Settings. "AL" will show. Use the + or - button to
adjust values.
2. Press the ALARM button to confirm and move to next item.
3. Press the TIME ADVANCE button any time to exit.
Activate/Deactivate Alarm:
• The alarm is active when set.
• Press the ALARM button to deactivate or activate the alarm. The alarm time will show for 2
seconds.
• Alarm Icon
will show when active.
Note: The alarm will only sound based on the local time and not the time advance time.
http://bit.ly/AtomicTime
icon.
HOW DO I SET A TIME ALARM?
4 |
P a g e
Hide quick links:
Advertisement
