Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for La Crosse Technology WS-6002U
Summary of Contents for La Crosse Technology WS-6002U
- Page 1 WS-6002U Atomic Clock Instruction Manual...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Topic Inventory of Contents/ Additional Equipment 3 About WWVB Quick Set-Up Guide Detailed Set-Up Guide Battery Installation Program Mode Function Buttons Time Zone Setting DST (Daylight Saving Time) Setting Language Selection Time Setting Calendar Setting 12/24-Hour Setting Selecting °F or °C Features &... -
Page 3: Inventory Of Contents/ Additional Equipment
United States at 60 kHz. The signal can be received up to 2, 000 miles away through the internal antenna in the Atomic Clock. However, due to the nature of the Earth’s Ionosphere, reception is very limited during daylight hours. The Atomic Clock will search for a signal every night when reception is best. -
Page 4: Quick Set-Up Guide
2) Wait 15 minutes for WWVB reception. 3) If there is no WWVB reception, manually set the time and date (instructions in the Program Mode). 4) Program the settings. 5) Mount the WS-6002U in a suitable location, where WWVB signals can be received. -
Page 5: Detailed Set-Up Guide
The numbers “0”, “1”, or “8” will appear in the hour position and the seconds will appear in the minute display. The Atomic Clock will either display the WWVB time, or discontinue the Battery Compartment Battery Cover... -
Page 6: Program Mode
(up to 6:00 am) until the signal is found successfully. If no signal is found during this period, the tower icon will not appear and the clock will search again at 12:00 am the next night. -
Page 7: Time Zone Setting
II) TIME ZONE SETTING 1) Hold down the “SET” button for 2 seconds, the default setting “-5EST” will flash in the Date LCD. 2) Press and release the “+” button to select the appropriate time zone. There are 13 time zones to choose from: -5EST Eastern Time (default setting) -6CST... -
Page 8: Language Selection
2) Press and release the “+” button to turn the DST off, as will be indicated by the display of “OFF” in the time LCD. 3) Press and release the “SET” button to confirm the DST setting, and to advance to select the language for the weekday. IV) LANGUAGE SELECTION FOR THE WEEKDAY 1) Hold down the “SET”... -
Page 9: Calendar Setting
VI) CALENDAR SETTING Note: When the WWVB signal is found, that date will over-ride the manually set date. 1) Hold down the “SET” button for 2 seconds (the selected time zone will flash), press the “SET” button 5 more times, until the default year “00”... -
Page 10: Selecting °F Or °C
VIII) SELECTING °F OR °C 1) Hold down the “SET” button for 2 seconds (the selected time zone will flash), press the “SET” button 10 more times, until the default “°F” flashes in the time LCD. 2) Press and release the “+” button to toggle between °F and °C. 3) Press and release the “SET”... -
Page 11: Wall Mounting
I) FOLDOUT TABLE STAND The foldout table stand leg is located on the backside of the atomic clock. The hinge is towards the center of the atomic clock, and the end (with no hinge) needs to be folded in towards the center. Once the foldout table stand is extended, place the atomic clock in an appropriate location. -
Page 12: Mounting
Replace with new batteries only, and of recommended size. Opening the casings invalidates the warranty. Do not try to • repair the units. Contact La Crosse Technology for Repairs. TROUBLESHOOTING Problem: The LCD is faint. 1) Replace the batteries. -
Page 13: Specifications
computers, or other radio controlled clocks. 4) Remove batteries for five minutes, reinsert and leave the unit alone overnight without pressing buttons. 5) If problems persist contact La Crosse Technology. Problem: Hour is incorrect (minute and date are correct). Solution: 1) Be sure correct time zone and daylight saving time are selected. -
Page 14: Warranty Information
Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd’s authorized service center. - Page 15 For warranty work, technical support, or information contact: La Crosse Technology, Ltd 190 Main Street La Crescent, MN 55947 Phone: 507.895.7095 Fax: 507.895.2820 e-mail: support@lacrossetechnology.com (warranty work) sales@lacrossetechnology.com (information on other products) web: www.lacrossetechnology.com All rights reserved. This handbook must not be reproduced in any form, even in excerpts, or duplicated or processed using electronic, mechanical or chemical procedures without written permission of the publisher.
Need help?
Do you have a question about the WS-6002U and is the answer not in the manual?
Questions and answers