Miscellaneous Selections; Store Macro Sets - ACC RC-85 Owner's Manual

Miscellaneous Selections

Various controller operating modes may be selected with the following
Configuration commands. Either Touch-Tone or dial-pulse (rotary) signalling
into the phone may be selected for patch operation. Control Operator and
Configuration control may be permitted or not permitted through the repeater
receiver (may be prohibited for overall security). The controller may be set up
for shared or unshared use of the phone line (see Chapter 8 - Sharing the Phone
Line). Finally, the logic sense of the User Function remote control logic outputs
may be selected to be low true or high true.
*5400 Touch-Tone patch signalling
*5401 Dial Pulse signalling
*5402 Enable control over repeater receiver
*5403 Disable control over repeater receiver
*5404 Phone line not shared
*5405 Phone line shared
*5406 UF Low True
*5407 UF High True
Hints: The commands are mutually exclusive in pairs, i.e. you may
select TT or DP, EC or DC, PLU or PLS, and UL or UH.
The EC and DC commands may not be entered through the
repeater receiver.
Serial Transfer Strobe Logic Sense
The Transfer Strobe signal in the expanded UF output mode may be selectable
high true or low true. The FC-1 board and the circuitry on page 8-6 requires
high true.
*5408 Serial Transfer High True
*5409 Serial Transfer Low True

Store Macro Sets

The currently active Control Operator enable/disable and mode selections may
be stored in one of four "Macro Sets" which may later be selected by the Control
Operator with simple commands. One macro select Control Op command in
effect performs many Control Op command functions. The macro sets also store
the user state of the link/remote base and the UF remote control logic output
states.
To store a macro set, simply set up the repeater as you wish to have it stored.
The Store Macro Set commands take a snapshot of the current setup of the
controller and stores it in the non-volatile memory in set 1, 2, 3 or 4.
*5911 Store Macro Set #1
*5912 Store Macro Set #2
*5913 Store Macro Set #3
*5914 Store Macro Set #4
(Programming the Controller)
RC-85 Repeater Controller Owner's Manual
7 - 11
TT
DP
EC
DC
PLU
PLS
FL
FH
STH
STL
MACRO
MACRO
MACRO
MACRO
V3 4/87