Command Code Prefixes; Emergency Autodial Numbers - ACC RC-85 Owner's Manual

Examples: Load the Patch Activity Timer with 45 seconds.
While unlocked, enter "*4006 45" all as one
transmission, or "*4006 45 #" over the phone.
Load the Hang Timer to 3 1/2 seconds (3500 ms).
Enter "*4010 3500".

Command Code Prefixes

Command code prefixes for Control Operator commands and the various classes
of User commands may be changed remotely. The command prefix desired is
entered directly as part of the Command Code Prefix Configuration commands.
*5000(prefix)
*5001(prefix)
*5002(prefix)
*5003(prefix)
*5004(prefix)
*5005(prefix)
*5006(prefix)
*5007(prefix)
*5008(command)
*5009(command)
*5010(prefix)
*5011(command)
*5012(prefix)
*5013(prefix)
*5014(command)
*5015(prefix)
*5016(prefix)
*5017(command)
Hint: To define the Patch Hangup command to be #, load an empty
command, i.e. "*5011".

Emergency Autodial Numbers

The ten Emergency Autodialer telephone numbers are loaded or changed with
these commands.
*520x(telephone number)
Hints: A location may be erase and left empty by entering nothing
for the phone number. For example, to erase slot 3, enter
"*5203".
The Emergency Autodial response messages are defined with
the Message Editor.
(Programming the Controller)
RC-85 Repeater Controller Owner's Manual
Control Operator Command
User Function Logic Output
Emergency Autodial
User Loadable Autodial
Autopatch
Link / Remote Base
User Autodial Load / Erase
Demo / Bulletin Board
Reverse Patch (from phone only)
Spare Audio (user cancels with #)
Patch Utilities
Patch Hangup
(load empty command to restore #)
Paging
Touch-Tone Access Mode Up / Down
S-Meter Readback
Extended User Autodial (Bank 1)
Extended User Autodial Load / Erase
Telephone Timer Extend
7 - 10
(x = autodial location 0-9)
CMD
CMD
CMD
CMD
CMD
CMD
CMD
CMD
CMD
CMD
CMD
CMD
CMD
CMD
CMD
CMD
CMD
CMD
V3 4/87