Hanging Up The Patch - ACC RC-85 Owner's Manual

Example: Autopatch Prefix = *
User sends "* 7273330".
Hints: If you don't want your users to have to "click" their mikes to
start dialing, select the Control Operator "Dial without
click" mode.
To cancel the patch before it dials, enter any Touch-Tone
during either pause.
If long distance is disabled by the Control Op, phone numbers
beginning with 0 or 1 or longer than 7 digits will be
ignored.
Phone numbers less than 4 digits are not accepted by the
Autopatch - they must be dialed through either autodialer.
With long distance enabled, phone numbers up to 18 digits are
accepted.
When the Autopatch Timer times out, the "30 seconds left"
message is generated. The user may then enter the Patch
Timer Extend command.
If the Activity Timer times out, a warning warble is generated -
reset the activity timer by sending a brief transmission.
Related Commands:
Config
Control Op Autopatch E/D, Long Distance E/D, Patch Timer E/D,
User

Hanging Up the Patch

The patch is normally hung up with Touch-Tone sequence, which may be as
simple as # or a multidigit sequence. While the patch is up, simply enter the
Patch Hangup command to take down the patch. The controller acknowledges
with the "Phone Hangup" message. If the patch is not up, the Hangup command
is ignored.
Command: (Hangup Command Code)
Example: Hangup Command Code = #
User sends "#".
(User's Features)
RC-85 Repeater Controller Owner's Manual
Controller says "Autopatch (pause) seven two seven
three three three zero (pause)". User clicks his mike at
either pause and controller dials the number
Phone Hangup Message, Patch Dialing Prefix, Autopatch
Timer, Patch Activity Timer, Patch Timer Extend
Timer, Autopatch Prefix, Patch Utilities Prefix, Patch
Hangup Prefix, Touch-Tone/Dial-pulse signalling
Cover Tone E/D/Always, Dial Needing/Without Click
Patch Cover Tone, Patch Timer Extend, Patch Hangup,
Patch Custom Hangup, Redial
Controller disconnects the patch and announces the
"Phone Hangup" Message.
5 - 3 V3 4/87