Configuration Commands - ACC RC-85 Owner's Manual

stored in the controller's non-volatile memory using a Configuration command.
The Control Op Macro Sets make it easy to select a special mode, like night
operation, or net mode. One easy to remember Control Op macrocommand can,
in effect, perform many commands.
One of the macro sets defines how the controller powers up. The repeater
owner can specify what features are enabled and disabled and what modes are
selected by storing a Control Op macro set.
The function of the various Control Op commands is described in the next
chapter, and the command groups include:
Macro Set Selection
Repeater Enable / Disable
Repeater Timer
Access / Control
User Command Enable / Disable
Link Enable / Disable
Autopatch / Autodial
Reverse Patch
ID
Tail Message
Alarm Enable / Disable
Speech Synthesizer
Kerchunker Filter Enable / Disable
Touch-Tone Mute / Unmute
Zero Hang Time Mode Enable / Disable
Low Courtesy Tone Select
Initialize

Configuration Commands

Configuration commands are the top secret, super secure commands which allow
you to remotely change User and Control Op codes, ID and other messages,
Morse code characteristics, courtesy tone selection, timer values, and Emergency
Autodial numbers. Since Configuration commands need to be very secure to
prevent tampering, they are accessible only when the controller is "unlocked".
Unlocking the controller accesses the configuration commands. When the
controller is locked in normal operation, any Configuration commands entered
are ignored. The controller is unlocked by entering a long Touch-Tone "unlock"
command. The actual command is field programmable by the repeater owner
among ten billion possible codes and is unique to each controller.
While unlocked, the various ID and response messages in the controller may be
edited, timer values may be changed, Emergency Autodial numbers may be
reprogrammed, and command codes may be modified. After we've finished a
sission of configuring, we "lock" back up the controller to that it's secure from
tampering.
(Command Code Structure)
RC-85 Repeater Controller Owner's Manual
4 - 3 V3 4/87