Activating The User Loadable Autodialer - ACC RC-85 Owner's Manual

Example: Autodial Bank 0 Load / Erase Prefix = 456
User sends "456 40".
Controller says, "Autodial Cancel" and erases location 40.
Command: (User Autodial L/E Prefix) (Location) (Phone Number)
or (User Autodial L/E Prefix) * (Location) (Phone Number)
[phone number secured from readback]
Example: Autodial Bank 0 Load / Erase Prefix = 456
User sends "456 40 9648034".
Controller says, "Autodial Write" and loads location 40
with the phone number 964-8034. Activating User
Loadable Autodialer allows phone number readback.
Example: Autodial Bank 1 Load/Erase Prefix = 457
User sends "457 * 20 7498330".
Controller says, "Autodial Write" and loads location 120
with the phone number 749-8330. Activating User
Loadable Autodialer does not allow phone number
readback.
Hints: If you don't want users to be able to erase and change
autodial numbers, either keep the autodialer locked
with the Control Op command, or keep the L/E
command code prefix secret.
If an autodial location is secured from readback, the Control
Op can bypass security option with User Autodialer
Unhide mode.
Write down what numbers are stored where so that you
won't lose track of what's in the controller.
Related Commands:
Config User Loadable Autodial L/E Command Code Prefix,
Extended User Loadable Autodial L/E Command Code
Prefix
Control Op User Autodial Unlock / Lock, User Autodial Hide / Unhide
User User Loadable Autodialer Activate

Activating the User Loadable Autodialer

Phone numbers stored in the User Loadable Autodialer may be dialed by
entering the User Loadable Autodial command prefix followed by the autodial
location. To call location 10 (which is in Bank 0), enter:
(prefix) 10
The controller responds with, "Autodial 10", pause, the phone number
"9648034", and pause. As with the Autopatch, briefly keying the mike at either
pause commands the controller to dial the number into the phone. If the Control
Op "Dial without click" mode is selected, the number will be dialed after the
second pause without needing to key the mike.
(User's Features)
RC-85 Repeater Controller Owner's Manual
5 - 7 V3 4/87