S&C Loadbuster Instruction Sheet page 7

NOTICE
Use a hand-driven screwdriver to loosen the four screws .
A power-driven screwdriver may damage the trigger
assembly .
Remove the four screws that fasten the trigger assembly to
the inner tube assembly, and withdraw the trigger assembly.
Discard the screws. See Figure 5.
Withdraw the moving contact assembly, and then slide off
the guide bearing. See Figure 6.
Carefully withdraw the inner tube assembly from the
chassis. See Figure 7.
Step 3
Step 4
Step 5
Disassembling the Loadbuster Loadbreak Tool
Trigger
assembly
Figure 5. Remove the four screws securing the trigger assem-
bly to the inner tube assembly. Remove the trigger assembly.
Figure 6. Remove the moving contact assembly and slide off
the guide bearing.
Figure 7. Remove the inner tube assembly.
Guide bearing
Moving contact assembly
Inner tube assembly
S&C Instruction Sheet 811-510
Screws (4)
7