S&C Loadbuster Instruction Sheet page 14

Inspecting the Key Parts of the Loadbuster Loadbreak Tool
Step 19
Anchor assembly inspection
Use an Emery cloth to polish the surface and remove pitting.
If the anchor assembly is severely pitted or burned, or if
the spring does not work, replace the anchor assembly.
See Figure 23.
Step 20
Resetting latch inspection
Examine the resetting latch and look for excessive wear on
the latching surface. The latching surface should be flat. Pull
the latch and check the springs. Replace the resetting latch
if it is deformed or damaged. See Figure 24.
Step 21
Hook frame attachment assembly inspection
Look for excessive burning or pitting on all contact surfaces
on the hook frame attachment assembly. Make sure the
pull ring hook is straight and the spring in the pivot contact
is working properly. The spring in the pivot should allow
movement in the same direction as the pivot contact. The
pivot also should move freely side to side. Replace the hook
frame attachment assembly if it is damaged. See Figure 25.
14
S&C Instruction Sheet 811-510
Key
Figure 23. Inspect the anchor assembly.
Resetting Latch
Detail view
Figure 24. Inspect the resetting latch.
Springs
Pivot
contact
Pull-ring
hook
Figure 25. Inspect the hook frame attachment assembly.
Springs
Check the condition
of the resetting latch
Pivot