Setting The Clock - Houghton Cool Top Trail 34 Operating And Installation Instructions

Fig. 28: COOL mode
Fig. 29: DRY mode
Fig. 30: FAN mode
Fig. 31: HEAT mode
Fig. 32: AUTO mode

5.10 Setting the clock

SET TIME
HOUR/MIN
Fig. 33: Setting the clock
Cool Top Trail 34
COOL mode
– In COOL mode the air distributor shows the
the vehicle will be cooled.
C
– Set temperature and fan speed can be selected manually.
– The compressor will switch off once the set temperature is
reached, it will automatically start up again once the room
temperature setting is exceeded.
DRY mode
– In DRY mode the unit is reducing the humidity inside the
vehicle.
C
– Set the temperature 1°C lower than the current room
temperature.
– The air distributor shows the
FAN mode
– In FAN mode the indoor air is circulated through the vehi-
cle without heating or cooling.
C
– The fan speed can be selected manually.
– The air distributor shows the
current room temperature.
HEAT mode
– In HEAT mode the air distributor shows the
the vehicle will be heated.
C
– Set temperature and fan speed can be selected manually.
– The compressor will switch off once the set temperature is
reached, it will automatically start up again once the room
temperature has fallen below the set point.
NOTE
When operating in heating mode in low ambient tempera-
tures the unit will periodically defrost the outside heat ex-
changer. The air distributor will display "dF" during defrosting
and then return to heating once the defrost is completed.
AUTO mode
– In AUTO mode the unit automatically selects heating or
cooling mode depending on the difference between cur-
C
rent room temperature and set point temperature.
C
– Set temperature and fan speed can be selected manually.
– The air distributor shows the
and the
temperature.
Press the
X
Press the
X
Press the
X
Press the
SET TIME
X
3x
To end the setting mode press the
or
X
10 seconds until the digits stop flashing.
10s
symbol in cooling mode as well as the set
key so that the hours digits are flashing.
SET TIME
or key to set the hour.
key so that the minute digits are flashing.
HOUR/MIN
or key to set the minutes.
symbol and
symbol.
symbol as well as the
symbol and
symbol in heating mode
key 3 times or wait
SET TIME
16