Installation In Offline Mode Without Salus Smarthome Application; General Informations - Salus HTR-RF(20) Full User Manual

7. Installation in OFFLINE MODE without SALUS SmartHome application

7.1 General informations

In OFFLINE mode (without application), you can use the UGE600 Universal Gateway or CO10RF coordinator to configure the system. Please note
that you cannot use both devices at the same time. Before installing the system you have to decide:
- to create a network using the UGE600 Universal Gateway (you can connect it to the Internet in the future)
- to create a network using the CO10RF coordinator (you can't connect it to the Internet)
REMEMBER! The UGE600 Universal Gateway and CO10RF coordinator are two different devices.
Each device creates and operates it's own network.
Universal Gateway -
Universal Gateway is
NOT CONNECTED TO THE INTERNET
You can use your devices locally without the Smart Home App. Gateway
works in this mode as standard ZigBee coordinator.
Please note! If your system has been installed in the OFFLINE mode using the UGE600 Universal Gateway and then connected to the Internet,
all devices should be found in the SALUS Smart Home application (using „Scan for equipment" button). All devices found in the application don't
need to be reconfigured, because all settings are automatically copied from the gateway.
Please note! If your system was created using the CO10RF coordinator and you would like to control the devices via the Internet, then all
devices should be reinstalled using the UGE600 Universal Gateway.
KL08RF
- Wiring Centre for 8-zone
underfloor heating (UFH).
RX10RF reacts to HTR-RF(20) signal automatically,
when it is paired with KL08RF wiring centre in
heating mode. It's not possible to pair directly
HTR-RF(20) with RX10RF.
You can use standard ZigBee network coordinator to install and use your
NOTE: CO10RF Coordinator is included in the set with the KL08RF
+ extension KL04RF
RX10RF
receiver
- CO10RF Coordinator
CO10RF Coordinator
devices.
Control Box.
41