Angelo Decor AD91218 Instructions

We hope you will find these instructions helpful in setting up your fountain.
If you have any issues with this item, please DO NOT return the unit to place of purchase.
Please visit our web site, www.angelodecor.com, for assistance and warranty information.
First unpack carton carefully, arranging parts safely in your working area.
Arrange all parts in your work area. Arrange all parts in your work area.
Feed 1 of the 2 light power supplies into the pump housing and through the center water
return hole ash shown above right.
Feed any excess cord back into the reservoir,
then set the light into the designated holder.
Thank you for buying an Angelo Décor Fountain!
Feed the cord from the pump and the lights down the cord pipe (shown above left) and Feed the cord from the pump and the lights down the cord pipe (shown above left) and
align with the groove at the base as shown above right. The light cable should be the end align with the groove at the base as shown above right. The light cable should be the end
that will connect to the transformer, not the end that has 2 connections. that will connect to the transformer, not the end that has 2 connections.
Next, take the other light fixture and feed the side which will connect to the
power through the opening in the bowl of the top feature.
Make sure the light tube is pressed into the opening (as shown above right), so
that it is secure.
Connect the cord from one of
the lights to the power supply.
Page 1 of 2