Error Message Screen - GRAUPNER ULTRA DUO PLUS 50 Operating Manual

14. ERROR MESSAGE SCREEN

The error will be displayed on the LCDisplay.
[ INPUT VOLTAGE
* The present input
voltage is _0.00V.
* Please check the
input voltage.
* The input voltage
must be 11-15V.
[ OPEN CIRCUIT
* A battery is
disconnected during
an operation.
* Please reconnect
the battery and
restart!
[HIGH OUTPUT VOLTAGE]
* Output voltage is
higher than the
selected cells or
voltages
* Please select
proper cells or
voltages
[ BAT. TEMP TOO HIGH]
* Battery temp is too
high to be operated!
OUTPUT _0.000V
BATT TEMP __0.0°F
[ BAL.VOLTAGE HIGH ]
* Balancer cells
voltage is too
high !!
over cell is [0]
[ LINK COMMAND
* Link order failed !
Error occured in the
counterpart channel !
[ CONNECTION
* selected cells and
cells connected to
the balancing port
are different !
* Please recheck and
restart !
] [ NO BATTERY
* A battery is not
connected to the
output
* Please connect the
battery to the
output then
restart !
] [ SHORT-CIRCUITED ]
* Output short-
circuited.
* Please check the
output.
[TEMPERATURE SENSOR ]
* A temperature
sensor is connected
in reverse or is
defective.
[ INTERNAL TEMP
* Internal temp is
too hot !
* Contact Hobby
Services if this
message appears
often.
[ BAL.VOLTAGE LOW ]
* Balancer cells
voltage is too
low !!
low cell is [0]
] [ NO SENSOR
* A temp-sensor is
not connected to the
port
* Please connect the
temp-sensor to the
port then restart !
] [ MOTOR FUNCTION
* Can not start the
motor function,
because other Output
is used !
* Please stop other
Output function to
start the motor !
Page
]
]
]
]
51/53
[ REVERSE POLARITY ]
* A battery is
connected to the
output in reverse !
* Please correctly
connect the battery
to the output.
[LOW OUTPUT VOLTAGE ]
* Output voltage is
lower than the
selected cells or
voltages
* Please select
proper cells or
voltages
[ BAT. TEMP TOO LOW ]
* Battery temp is too
low to be operated!
OUTPUT _0.000V
BATT TEMP __0.0°F
[DATA COMMUNICATION ]
* Something is wrong
with the internal
circuit.
* Contact Hobby
Services
[ CALIRATION DATA ]
*Either calibration
data or internal
circuit might have
been damaged.
[MOTOR OVER CURRENT ]
* Please reconnect
the motor and
restart!