Kenwood AT320A Instructions Manual page 3

before use
Wash the parts: see 'cleaning'
key
a base
b rubber seal
c blade unit
d milling jar
e assembled mini chopper/mill
f storage jar and lid (4 supplied)
to use the mini
chopper/mill
1 Put your ingredients into the jar.
Don't fill above the maximum level
indicated on the jar.
2 Ensure the rubber seal is snugly in
place on blade unit.
3 Turn the blade unit upside down.
Lower it into the jar, blades down.
4 Screw the base onto the jar until
it's finger-tight.
5 Remove the high speed outlet
cover 1.
6 Place the mini chopper/mill over
the outlet, turn clockwise and at
the same time push down until
the attachment engages 2. Then
turn further clockwise until the unit
locks into position.
7 Switch on to maximum speed.
8 Once the desired consistency
has been achieved switch off
and remove the mini chopper/mill
supporting it with both hands.
hints
Herbs are best milled when clean
l
and dry.
Always add a little liquid when
l
blending cooked ingredients to
make baby food.
When milling coffee beans, the
l
longer the running time the finer
the result.
cleaning
Always switch off and unplug
l
before removing the attachment
from the kitchen machine.
Dismantle the attachment fully
l
before cleaning.
English
For easier cleaning always wash
l
the parts immediately after use.
jars/lids/base
Wash by hand in hot soapy water.
The jars, lid and base may also be
washed in the dishwasher.
blade unit
1 Remove and wash the rubber seal.
2 Brush the blades clean under a
tap. Keep the underneath of the
unit dry.
3 Leave to air dry.
service and customer
care
UK only
If you need help with:
•
using your attachment
•
servicing or repairs (in or out of
guarantee)
call Kenwood Customer Care on
Z
023 9239 2333.
•
spares and attachments
call 0844 557 3653.
Z
other countries
If you experience any
l
problems with the operation
of your attachment, before
requesting assistance visit
www.kenwoodworld.com.
Please note that your product
l
is covered by a warranty, which
complies with all legal provisions
concerning any existing warranty
and consumer rights in the country
where the product was purchased.
If your Kenwood product
l
malfunctions or you find any
defects, please send it or bring
it to an authorised KENWOOD
Service Centre. To find up to date
details of your nearest authorised
KENWOOD Service centre visit
www.kenwoodworld.com or the
website specific to your Country.
Designed and engineered by
l
Kenwood in the UK.
Made in China.
l
3