Panasonic ET-MDN12G10C Operating Instructions Manual page 11

Note
f "SLOT NX" is a name of the slot unique to Panasonic supporting the signal input for the 4K
image.
f The video signal that can actually display will vary depending on the projector that the
Interface Board is installed. For details, refer to the Operating Instructions of your projector.
f When the projector is in the standby state, signals are not output from the <SDI 2 输入/1
输出> terminal and <SDI 4 输入/3 输出> terminal.
f To ensure images are transmitted correctly, use 5C-FB or higher (5C-FB, 7C-FB, etc.), Belden
1694A or higher, or Canare Electric L-5.5CUHD for the connection cable. Furthermore, the
maximum lengths of cables that can be used are as follows. However, these maximum cable
lengths are provided as a guide, and are not a guarantee of transmission distances.
g SD-SDI signal, HD-SDI signal, and 3G-SDI signal: 150 m
g 6G-SDI signal: 80 m (110 m if L-5.5CUHD is used.)
g When 12G-SDI, differs depending on the setting of [Display Options] menu → [SLOT IN] →
[SDI Mode] of the projector.
When [SDI Mode] is set to [Input], 50 m (100 m if L-5.5CUHD is used.)
When [SDI Mode] is set to [Output], 50 m (90 m if L-5.5CUHD is used.)
f When [Display Options] menu → [SLOT IN] → [SDI Mode] of the projector is set to [Output],
attach a terminating resistor (75 Ω) to the terminal to which a device is not connected as an
output destination.
f For the BNC connector of the connection cable, use one that supports the coaxial cable and
types of signal to be used.
Specifications
ENGLISH - 11