Installation; Installation Instructions - UFO -L/12 User Manual

3. INSTALLATION

3.1 Installation Instructions

Installation on the wall: Attention! The appliance must be installed on the solid surfaces like concrete
and metal.
Never install on flammable surfaces!
See pages 4-7 to come up with the most appropriate installation method for your UFO.
1- Drill four 8 mm diameter holes on the wall to the place where the unit will be placed with the
distances shown in (Figure-1)
2- Insert the 8 mm diameter wall plugs,supplied with the unit ,into the holes.
3- Mount two of the L shaped legs on the wall using the 5x40 screws supplied with the unit.
4- Mount the other L legs on the unit using the six M5 screws and the small wrench as shown in
(Figure-2) (corresponding nuts are already built in on the body of the unit)
5- Mount and fix the L shape legs on the wall and on the unit respectively,using the M8x13 bolts and
nuts and the washers as shown in (Figure-3) and tighten by using the wrench supplied.
6- Depending on the area to be heated the angle of the unit can be adjusted between 0-45 degrees
by the help of M8 bakelite head bolt and nut fixture.
7- Before operating the unit joints should be checked once again.
UFO User Manual & Certificate Of Warranty
4
Figure-1
Figure-4
Figure-2
Figure-3